Shellab SWPK Manual do Utilizador descarregar pdf (Página 2)

2 | P a g e

SWPK INSTALLATION

Revised: May 8, 2014

Part Number (Guide): 9920698

Sheldon Manufacturing

300 N. 26th Ave

Cornelius, OR 97113

PHONE 1-800-322-4897

(503) 640-3000

INTRODUCTION

The SWPK Sheldon Water Purification Kit is designed to remove particulates and calcium from

water sources for the SHC10, SCH10R, SHC28, and SHC28R Humidity Chambers and their 230

volt variants, as well as the SCO26H and SCO26H-2 Humidified CO

Incubators*. The kit also

adjusts water pH and water resistance to levels that will not corrode the units’ interiors, or adversely

affect the performance of steamers and other major components. This installation guide covers how

to install the SWPK.

*These units were previously designated the HC9, HC9R, HC30, HC30R, and 2428H.

TAP WATER

This purification kit is intended to purify standard tap water. Do not connect it to a deionized water

source. Use of deionized water will likely cause corrosive damage to major functional components

and the metal interior surfaces of humidity chambers and humidified CO

Incubators.

WATER OUTPUT EXPECTATION

18 megohm-cm of resistivity can be achieved with the SWPK. The Absorber filter removes free

chlorine, organics, phosphate complexes, and turbidity. The Universal filter removes ionizable

constituents, except free carbon dioxide and silica. The Universal filter reduces the ion

concentration level equivalent to a single distillation.

WATER PRESSURE

The SWPK is designed to work with tap water sources that provide 60 – 70 Pounds per Square

Inch of water pressure. Do not connect the SWPK to sources that exceed 120 PSI!

The regulator should be set to supply 5 PSI to the water filters.

1 2 3 4 5 6 7 ... 12 13

Sem comentários

Shellab SWPK Manual do Utilizador Página 2